Някой да е открил решение за голф2/поло, как да се избие щифта? Аз си мисля освен да се нагрее, и да се пробва да се избие,но то и щифта ще се разшири като се нагрее.Трябва да има някакъв начин щом са сглобени веднъж,но предполагам, че са сглобени с нагряване.
Едит:
Ето какво открих:
Replacing door pins – stop that saggy feeling!
You need:
door pinNew hinge pins, part no.321 831 421, 2you need 2 pins per door.
Plastic bushes for pins. The parts guy at VW didn;t mention to me that there is a small plastic bush in the middle part of the hinge, so if you buy the pins get the bushes too.
I had to make a couple of copper bushes otherwise i’d have been stuck, but they will last longer than the plastic ones anyway.
Method
1. Remove the door trim, so the speakers, electric windows etc, can be disconnected and the loom removed from the door.
2. Disconnect the check strap. The pin on the check strap will be held in by either a split pin or a push on grip washer.
3. You will need a helper now to hold the door or remove the two bolts that hold the door onto the body.
4. Stand the door on its end, i stood mine on an old blanket. this gives you the best access to the hinge.
5. Now you will need a set of long (8-10 inches) punches. They have to be long so you can clear the edges of the door, especially the top hinge, due to the door curving over the top of the hinge.
get your helper to steady the door while you knock the pins out. The bottom hinge pin knocks out upwards and the upper one downwards. They are tight but come out easy once they start moving.
6.Once the hinge is separated you may find the remains of the plastic bush that sits in the middle section of the hinge. I didnt have any replacements, so had to scrounge around the garage for something suitable. Luckily i found a small piece of brass tube that was a snug fit in the hinge, unluckily it was too narrow for the new pin, so i cut it to length, hammered it into the hinge and then carefully drilled it out to the correct size.
7. Then its just a case of oiling the pin and putting the hinge back together.
IMPORTANT PART !!! take note which way round the middle section of the hinge fits ,as it is shaped !!!!!
8. Refit the door and adjust the door catch as required.
The new pins are slightly longer than the old ones, they need to be knocked in until the grooved part has dissapeared into the hinge
The new lower pin fitted, ignore all the crud on the bodywork its Waxoyl !
doorpin fitted
I hope it helps. Its not a bad job to do, provided youve got some help and the right punches, it took about an hour to do the driver door. The end result is worth all the effort. Thanks.
Contributor: Forum user MarkH
http://sciroccoregisterforum.co.uk/faq/ ... rk/page/2/Ако може някой да го преведе, че аз не се наемам с моя английски.