Скоро ще го пробвам и ще пиша какъв е ефекта.
Ето и какво точно се прави
hought id just add this with pics as ive just set mine,gotta do it again as ive replaced bits since then,
fuel pressure gauges { bosch-k-jet guages with all the right adapters}
fit adapter to one side of the guage
fit the other side of the guage { with no adapters} to the centre fuel metering head .
fit the adapter end to the fuel line u just took off,
hang guage vertical, and purge trapped air,
make sure gauge is open and start engine ,
this is control pressure,
close gauge,
this is ur system pressure,
mines 5.5 bar as i already added shim, gonna take it out weekend back to 5 bar.
drill slowly,light pressure { thin metal} to reveal allen screw. { drilled slightly to the left so had to open out with snips}
adjust make to 48psi
realease fuel pressure,
unscrew gauge and re fit fuel lines.
as u adjusted pressure u need to set co back to 2% , i used the handy co machine
Не е ли възможно да се запомни началното положение и ако не харесаш резултата да се върнеш в изходно положение?
